When the built-in memory becomes full, will the recording be automatically saved to the memory card, or vice versa (relay recording)?

    16-May-2012
    8201089000

    Solution

      You can activate relay recording so if the memory you are using becomes full while recording movies, the recording will continue automatically on a memory card.
      When recording in the built-in memory, you can choose to use only memory card A for relay recording ( ), or use both memory cards ( ). When recording on memory card A, you can use memory card B for relay recording ( ).
      Confirm the following information regarding the relay recording settings.

      Insert a memory card that contains no video recordings into the card slot of the memory card you want to use for relay recording.
      • When relay recording from the built-in memory: memory card slot or both memory card slots.
      • When relay recording from memory card A: memory card slot only.
      NOTE
      • You cannot use relay recording from the built-in memory to memory card B. When using a single memory card, be sure to insert it into memory card slot .
      • During Story Creator mode, relay recording and double slot recording are not available.

      1. Set the mode switch to <M> or <CINEMA>.

      2. Turn on the camcorder.

      3. Touch [ ].



      4. Touch [ ].



      5. Touch [ ].



      6. Drag your finger up and down bring [ Rec Media for Movies ] into the orange selection bar, and touch inside the frame on the right.



      7. Touch [ ] or [ ].



      8. Touch [Relay Recording].



      9. Touch [ ] or [ ].
      If [ ] was selected in Step 8, then you can only choose [ ].



      10. Touch [ ] to close the menu.

      NOTE
      • There will be a momentary stop in the scene at the point where the camcorder switches from one memory to another.
      • Any of the following actions will deactivate the relay recording function:
      - Turning off the camcorder.
      - Opening the double memory card slot cover.
      - Changing the position of the mode switch.
      - Changing the camcorder’s operating mode.
      - Changing the memory used for recording movies.