Using the Unicast Communication Mode
31-Oct-2011
8100081200
Solution
The unicast communication mode makes communication by using the unicast method in sending status from the printer, which is not normally performed by the broadcast communication mode.
If you want to use the unicast communication mode, set the network board settings to enter into the unicast communication mode using FTP Client.
IMPORTANT
If you want to use the printer in a network environment in which the broadcast communication mode is not used, you need to switch the mode to the unicast communication mode. However, because this affects the administration of your network environment, be sure to consult your network administrator if you want to use the unicast communication mode.
NOTE
If the message <Network Board Error> is displayed in the Printer Status Window after setting the unicast communication mode, refresh the display of the Printer Status Window.
1. Run Command Prompt or MS-DOS Prompt.
From the [Start] menu, select [Programs] > [Accessories] > [Command Prompt].
From the [Start] menu, select [All Programs] > [Accessories] > [Command Prompt].
2. Enter the following command, then press the [ENTER] key on your keyboard.
ftp <the IP address of the printer>
Input Example: ftp 192.168.0.215
3. Enter "root" as the user name, then press the [ENTER] key on your keyboard.
4. Enter the password, then press the [ENTER] key on your keyboard.
If the password has not been specified yet, do not enter any value, but press the [ENTER] key on your keyboard.
5. Enter the following command, then press the [ENTER] key on your keyboard.
get config <the file name>
The config file is downloaded. The characters entered for <the file name> become the name of the downloaded config file.
NOTE
The download directory for the config file varies depending on the operating system or settings.
If you cannot find the config file, browse the config file using the file browse function of the operating system.
6. Using Notepad, etc., open the downloaded config file.
7. Edit "YES" to "USE_IP_PORT_NAME".
Input Example: USE_IP_PORT_NAME. :YES
8. Save the config file.
9. Enter the following command, then press the [ENTER] key on your keyboard.
put <the file name> CONFIG
NOTE
In <the file name>, enter the name of the config file that was entered when the file was downloaded.
10. Enter the following command, then press the [ENTER] key on your keyboard to reset the network board.
get reset
After completing the reset of the network board, the settings are effective.
NOTE
The settings also become effective by restarting the printer (Turn OFF the printer once, wait for 10 seconds or longer, and then turn it ON.).
11. Enter "quit", then press the [ENTER] key on your keyboard.
12. Enter "exit", then press the [ENTER] key on your keyboard.
Command Prompt or MS-DOS Prompt exits.
IMPORTANT
If you want to reset to the normal mode (the broadcast communication mode), edit "USE_IP_PORT_NAME" to "NO".
Input Example: USE_IP_PORT_NAME. :NO
NOTE
If the message <Network Board Error> is displayed in the Printer Status Window after setting the unicast communication mode, click the [Refresh] button in the Printer Status Window.