Getting Ready to Print (Preparing the Ink and the Paper)
19-Aug-2008
8200282800
Solution
CAUTION
- Do not touch the [ink sheet] of the cartridge, or pull out the [ink sheet] or papers.
- There may not be enough ink left for the allotted sheets, or paper jams or poor printing may result.
- Do not handle the cartridge with wet or sweaty hands.
- Please use only cartridges specified for use with the [SELPHY ES] series (Cartridges for the CP series cannot be used).
- Do not apply excessive force to the cartridge.
- The paper may come out from under the clips. In this case, push the paper back under the clips.
1. Check that the [ink sheet] is tight and that the paper is correctly loaded in the cartridge.
[Ink sheet]
Paper2. When inserting the cartridge into the printer, if the [ink sheet] is so slack it catches, insert the [cleaner unit] and turn it slowly to take up the slack.
Insert the [cleaner unit]. Gently rotate in the counterclockwise direction to take up the slack.** It will not be possible to use all the paper for printing if you overwind the ink sheet.
3. Slide the <cartridge cover lever> up to open the <cartridge cover>.
Push up the <cartridge cover lever>. Open the <cartridge cover>.4. If there is a [cleaner unit] inside the printer, grasp it and remove it.
5. Make sure that the cartridge is oriented as shown by the direction indicator on the inside of the printer, and insert the cartridge until it clicks into place.
Direction indicator [Easy Photo Pack] (Insert the [Easy Photo Pack] so that the side with the protective paper is facing the front.)6. Close the <cartridge cover>.
7. Set up and connect your SELPHY printer in the following manner for safe use.
Connect the supplied [power cord] to the printer. Insert the plug into a power outlet.
Leave more than 15 cm (6 in.) of clearance at the front and back of the equipment and 10 cm (4 in.) of clearance on both sides.CAUTION
- Do not place the equipment on an unstable or tilted surface. There is risk that the equipment may fall and cause injury.
- Be sure to select a safe place to avoid tripping over the [power cord].
- Do not block the
<air vents> on the back of the printer.