Adjusting Color on the Trailing Edge of Sheets (iPF6300/iPF6350)
03-Mar-2010
8200772500
Solution
If printed sheets are affected by banding in different colors by the trailing edge (about 20–30 mm (0.8–1.2 in) from the edge), try adjusting the feed amount of the trailing edge of sheets.
NOTE
- For banding in different colors over the entire printed area of sheets or rolls (not only at the trailing edge of sheets), try adjusting the overall feed amount.
- This adjustment is only possible when feeding paper from the Top Paper Feed Slot that can be set up with a margin on the trailing edge of 3 mm (0.12 in). Paper that does not allow a margin of 3 mm on the trailing edge is automatically ejected, and the adjustment is not available.
1.Load one sheet of unused paper of at least A4/Letter size.
NOTE
- Always make sure the loaded paper matches the type of paper specified in the settings. Adjustment cannot be completed correctly unless the loaded paper matches the settings.
- We recommend using the type of paper you use most often for adjustment.
2.On the "Tab Selection screen" of the Control Panel, press 
or 
to select the Settings/Adj. tab (
).
or to select the Settings/Adj. tab ().
NOTE
- If the "Tab Selection screen" is not displayed, press the "Menu" button.
3.Press the "OK" button.
The "Set./Adj. Menu" is displayed.
4.Press 
or 
to select "Adjust Printer", and then press the "OK" button.
or to select "Adjust Printer", and then press the "OK" button.5.Press 
or 
to select "Adj Far Ed Feed", and then press the "OK" button.
or to select "Adj Far Ed Feed", and then press the "OK" button.6.Press 
or 
to select "Yes", and then press the "OK" button.
or to select "Yes", and then press the "OK" button.A test pattern is printed for adjustment.
"C1" is displayed on the Control Panel.
7.Examine test pattern "C1". Determine the pattern in which banding is least noticeable. Press 
or 
to select this pattern number, and then press the "OK" button.
or to select this pattern number, and then press the "OK" button."C2" is displayed on the Control Panel.
8.Examine test pattern "C2". Again, determine the pattern in which banding is least noticeable. Press 
or 
to select this pattern number, and then press the "OK" button.
or to select this pattern number, and then press the "OK" button.The adjustment value is now registered, and adjustment is complete.
NOTE
- If streaks seem least noticeable in two patterns but you cannot decide which one is better, choose an intermediate value. For example, choose 17 if you cannot decide whether pattern 16 or 18 is better.
